1.携带减水剂
1. Carry water reducing agent
减水剂是一种混凝土外加剂，可以减少用于混合的水量，同时保持混凝土的塌陷。它可以随车携带，并且可以很好地调节混凝土。但是，参加减水剂时，必须记住上野站的实验室里有人。否则，混凝土质量不够，驾驶员必须承担后果。
Water reducing agent is a kind of concrete admixture, which can reduce the amount of water used for mixing while maintaining the collapse of concrete. It can be carried with the car and can adjust the concrete well. However, when participating in the water reducing agent, you must remember that there are people in the laboratory of Ueno station. Otherwise, the concrete quality is not enough, and the driver must bear the consequences.
2.返回工厂检查水箱中的水量
2. Return to the factory to check the amount of water in the water tank
每次下火车返回车站时，请检查小型混凝土搅拌车水箱中的水量。紧急情况下，随时可以将水箱中的水充满。
Every time you get off the train and return to the station, please check the amount of water in the water tank of the small concrete mixer. In case of emergency, the water tank can be filled at any time.
3.出厂前检查混凝土质量
3. Check the concrete quality before delivery
每个混凝土卷轴的质量可能会因材料不同而发生变化。安装后离开混凝土时，请务必检查混凝土在储罐中的坍落度以及混凝土的易用性，并注意混凝土的早期凝固和混凝土的分层沉降。
The quality of each concrete reel may vary depending on the material. When leaving the concrete after installation, be sure to check the slump of the concrete in the storage tank and the ease of use of the concrete, and pay attention to the early setting of the concrete and the layered settlement of the concrete.
4.减少车辆行驶时间
4. Reduce vehicle driving time

混凝土的运输距离通常直径在30公里以内。在离开汽车之前，请规划道路和车辆的交通状况，并尝试减少小型混凝土搅拌机在道路上的时间。
The transportation distance of concrete is usually less than 30 km in diameter. Before leaving the car, please plan the traffic conditions of roads and vehicles, and try to reduce the time of small concrete mixer on the road.
5.优先卸载以减少损失
5. Give priority to unloading to reduce losses
如果长时间遇到人为或非阻力因素导致卸货，则应始终检查小型混凝土搅拌罐中的混凝土状况。一旦发现混凝土开始凝固。向负责人报告后立即卸货，以防止整个包装箱被报废。
If unloading is caused by human or non resistance factors for a long time, the condition of concrete in small concrete mixing tanks shall always be checked. Once it is found that the concrete begins to set. Unload immediately after reporting to the person in charge to prevent the whole packing box from being scrapped.
其次，自上料搅拌输送一体机需要随时清洁。
Secondly, the self feeding mixing conveyor needs to be cleaned at any time.
1.随时冲洗
1. Wash at any time
每次卸货后，使用带有水枪的油轮冲洗水口，叶片，入口，水箱和水箱的角，以防止混凝土积聚，凝结后不易清洗。站起来。
After each unloading, use an oil tanker with a water gun to flush the water inlet, blades, inlet, water tank and the corners of the water tank to prevent concrete accumulation and difficult to clean after condensation. stand up.
2.关闭后彻底清洁油轮
2. Clean the tanker thoroughly after shutdown

当前标题：自上料搅拌输送一体机车身油箱体积改善方法
当前地址：https://www.cdcxhl.com/hangye/zbljbc/n67338.html

声明：本网站发布的内容（图片、视频和文字）以用户投稿、用户转载内容为主，如果涉及侵权请尽快告知，我们将会在第一时间删除。文章观点不代表本网站立场，如需处理请联系客服。电话：028-86922220；邮箱：631063699@qq.com。内容未经允许不得转载，或转载时需注明来源： 创新互联